BMW F650 Forums banner
worn
1-7 of 7 Results
  1. F650 Single Discussion
    Hi, Has anyone ever had worn out heated grips? They still work fine, but one has a hole in it thanks to over use, and the other one is getting thin. By the looks of it the heating element is integrated in to the grip rubber. So... Firstly can anyone tell me if I am right. Secondly can someone...
  2. F650 Single Discussion
    Had an interesting cut out of power yesterday. Lost all dash lights and engine cut out. Assumed battery terminals had come slightly loose-but no. Lights were flicking on and off intermittently and managed to turn over-but cut out again when upright to move off. I wiggled the wiring loom and...
  3. F650 Single Discussion
    Hi all :-D My bike has started to shake while riding it normal. I have been told I need new headstock bearings. Would this couse the bike to start shaking. :wall: Bob :-(
  4. F650 Single Discussion
    Here a picture of what happens when someone replaces a front sprocket incorrectly. :wall: :wall: :wall: :wall: http://www.enduroalexis.com/enduroalexis_completed_035.htm Enjoy, Alexis.
  5. F650 Single Discussion
    Just checking over the bike this morning and noticed the rear tyre tread getting a bit low, about 4mm in centre of wheel. I was a little surprised as its only covered 1800 miles since new. It's a metzeler enduro 3 sahara, is this usual? Heard the TKC 80's are good ? Any recommendations :think:
  6. F650 Single Discussion
    Guys, I need some advise on some wear I'm seeing on my 98S F650ST's fork chrome. It is not pitting, rather a smooth wear spot on each chrome stancion about 2cm x 1 cm at the front just above the seal when uncompressed on the centre stand. Off the centre stand with me on the bike the wear spot...
  7. F650 Single Discussion
    I've got a 96 F650 with 45,000 on the clock. I recently changed gear and heard a werring noise, and then couldn't select a gear. Closer examination shows the teeth on the shaft comming out of the gearbox have worn flat and the front sprocket is just not gripping the shaft. Is this usual? I...
1-7 of 7 Results
Top