sump

After doing an oil change on my 95 F650 it stripped the thread in the sump I tried a heli coil in it with no luck then started to think how am I going to fix this, after searching around on my garage I found the perfect solution to this problem and for any one else who wants to do the same is...

In an effort to get more hands on and save a bit of money, i have attempted to carry out a oil, air and spark plug change. Apart from an initial bad language attempting to get the spark plugs out the major problem was the sump plug. The plug is stuck fast, and being made of metal softer than a...

Hi, Just replaced the old sump plug with the part from BMW for repairing stripped sumps. Trouble is I now have a slight leak from the new plug. Should the plug which cuts a new thread have had a crush washer fitted. I dont want to over tighten as I fear that I may strip the sump threads...

Yey or nay?

Hi, I have been reading about 'freeze plugs' on the chain gang website (FAQ) Does anybody know where I can buy them in the UK? I have searched on the web for 'universal sump plug', 'Freeze plug' and even the company name of the guys that make them - with no luck! Any help would be good... cheers!

Jusy a quick one, I need a new sump plug for my F650GS as the old one is knackered, can't seem to fine one on motorworks though :?. Anyone know where I can get one that will fit online? Cheers, Matt

Not from sadness (although it makes me sad to see it...), but a bit of oil is leaking out of the sump plug when the engine gets hot. I did an oil change a couple of months ago and replaced the copper washers and torqued up properly, but it's obviously not enough. I'm supposed to be popping to...

Just spent long time getting hands dirty(new chain,sprockets/scottoiler/oil change,etc) Now noticed threads gone on sump. :wall: Looking back at past posts,motorworks do a repair kit ,anyone fitted one ? are they easy? at moment plug is in with p.t.f.e. tape, :roll: very slight leak ,but dont...

I know this has been covered to a degree before but...... On my last oil change I finally got the chance to swap over from the standard F650 sump oil drain plug to the oft recommended K90 oil drain plug. It's only when you've got them both in your hand that you realise what all the fuss is...

Anyone have any experience of using the BMW repair sump plug kit thingy? I have one ordered as my sump plug weeps constantly.

I finally had a go at doing my oil change the other day. All went fine but I ignored all warnings and suspect that I have overtightened the sump plug. I'm now getting a slow leak from it. I read on the FAQ board that there is a kit to fix this. Has anybody tried it? Are there any other options...

Guys & Gals, I need your colective help once more. I a trying to remove my sump plug but the hexagon head has round off. The blood plug has stuck and I need to empty the oil. Any tips will be much appreciated

I have a feeling the thread has gone on my sump. I can't do the plug up tight, and when I removed it today I had little bits of thread in the plug's thread. I have now done it up as tight as I dare and it's weeping slightly. (I've tied it up with wire just in case!) Is this a BMW fix it job, or...