BMW F650 Forums banner
shaft
1-10 of 10 Results
  1. F650 Single Discussion
    Hi Well I am down to the main shaft drive sprocket... The Clymer Manual says to put a 'soft washer' between the main sprocket and the sprocket of the clutch basket.... then take the nut off... Agghhhh.. is this the only way? Really worried about damaging the main sprocket or clutch...
  2. F650 Single Discussion
    Hiya Well after BMW poortugal delivered all my bits - I got round to fitting them yesterday.. or so I thought... I had ordered replacement seals for all the thermostat housing area and water pump area along with the replacement collet for the pump... But.. the darn little collet won´t go...
  3. F650 Single Discussion
    Hi Can anyone help My troublesome F650CS has an oil leak from the clutch operating shaft as it enters from top of crank case. Seal has been replaced but no improvement, garage are now suggesting replacing clutch operating shaft. Any advice would be much appreciated. Dr Oxford
  4. F650 Single Discussion
    Hi All, I have just bought a rather poorly sounding GS version of the F650. My local bike shop has stripped it down and the major problem has turned out to be the balance shaft bearing completely collapsed. (not the only problem due to bad workmanship) It looks like there has been an extra...
  5. F650 Single Discussion
    Can anyone tell me if the clutch actuation shaft seal on a Funduro is easy to replace? Is it just a matter of taking the clutch arm off, pulling the old seal out, and popping the new one in? Or is there more to it than that?
  6. Chatter
    What is it about other BMW owners and this fixation with Shaft drive ? If its not shaft drive its not a proper BMW they say. We have two shaft drive BMW's in our household an 1100GS (90,000miles) and a K1200LT(40,000). The GS is now on its 3rd Final Drive Main Bearing and the LT has just failed...
  7. F650 Single Discussion
    As some might know, I am doing up an engine to replace my old one. I have had to remove a few of the shaft seals eg the gear selector shaft, water pump, clutch seal. These do not seem to be BMW parts as they should be used by alot of machines. My question is does anyone know where they can be...
  8. F650 Single Discussion
    Here a picture of what happens when someone replaces a front sprocket incorrectly. :wall: :wall: :wall: :wall: http://www.enduroalexis.com/enduroalexis_completed_035.htm Enjoy, Alexis.
  9. F650 Single Discussion
    I heard a rumour that BMW are working on turning the F650 into a shaft drive bike. This was not down the pub at 2 am, but at a bike show. I know there is always a lot of talk, but look what happened. They talked of a 1200 GS, a 1200GS ADV, an HP2, an HP1, an F800, a more off-road orientated...
  10. F650 Single Discussion
    I've got a 96 F650 with 45,000 on the clock. I recently changed gear and heard a werring noise, and then couldn't select a gear. Closer examination shows the teeth on the shaft comming out of the gearbox have worn flat and the front sprocket is just not gripping the shaft. Is this usual? I...
1-10 of 10 Results
Top